| |
Main
Date: 20 Dec 2006 22:46:53
From: Rudy Fichtenbaum
Subject: reeding a Sheraton bed post
|
Does anyone know what type of router bit you would use to reed a
Sheraton bed post?
Rudy
|
|
| |
Date: 20 Dec 2006 17:03:16
From: Andy Dingley
Subject: Re: reeding a Sheraton bed post
|
Rudy Fichtenbaum wrote:
> Does anyone know what type of router bit you would use to reed a
> Sheraton bed post?
You wouldn't - you can't reed (for any useful quality) with a router.
The problem with reeding on a vertical router is that you can't get a
sharp bottom to the vee - there's always a flat base to it. If you want
a sharp good-looking reed, do it the old way and cut it (or at least
finish it) by hand.
Start out with a lathe, which you probably have already to turn them or
you can make a crude one up from 2x4s -- it doesn't need to spin. Now
make the enormously useful two plywood boards "gutter guide" and a
headstock indexing disk. With this and a wide plywood baseplate on your
router you can cut a series of equally spaced vee grooves on the post.
Use any pointed vee cutter because these are only rough guides for
spacing and to remove the bulk of the wood. The finishing of the reed
is done by hand with a home-made scratch stock. Make a special curved
stock up just for this task - it's easier than trying to guide a
straight stock on a round post. If you have one, a suitable wooden
moulding plane might also be useful as an intermediate step.
Try and find a copy of Fine Woodworking magazine or their reprint book
"Beds and Bedroom Furniture". There's a detailed article in there on a
Sheraton bed with reeded posts. The author uses the lathe as a
workstand and hand carves them.
|
| |
Date: 20 Dec 2006 16:14:52
From:
Subject: Re: reeding a Sheraton bed post
|
Hi Rudy,
I wasn't aware of a design called "Sheraton" until I saw your post and
found this:
http://www.taunton.com/finewoodworking/store/pages/fw_toc_113.asp
Would something like this work:
http://www.amanatool.com/bits-fv/54211.html
(the one on the left)
-or-
http://www.amanatool.com/bits-fv/54211.html
I'm assuming that the bed post is round. You would utilize the center
section of the bit in a fixture that would allow you to index the
rotation of the bed post. Guidance would require a creative solution
if the bed post weren't straight.
I went looking for a bit that I've seen used to make backer boards for
steel rule dies. It looks like a roundover bit but it comes to a
point. Couldn't find it.
Ed Bennett
ejb@ts-aligner.com
http://www.ts-aligner.com
Rudy Fichtenbaum wrote:
> Does anyone know what type of router bit you would use to reed a
> Sheraton bed post?
>
> Rudy
|
|
